Nicolas Bazoge

I have a patcher with 16 sliders controlled by a MIDI controler (MIDI Fighter Twister) using the MIDI mapping feature (button on the bottom of the patcher). When I open the mappings window, all controls are there and all works well. 

But when I close my saved patcher and reopen it, the mapping does'nt work anymore, even though all controls are still in the mappings window...

I precise that I saved the mapping to a file before saving my patcher, and closing it. 

If I goes to MIDI Mapping mode again, I notice that all the sliders have a blue dashed frame, and need to be mapping-enabled again so that the mapping works again.

Is it the normal behavior of this feature? 

Can't the mapping be done once and for all so that it works properly each time the patcher is opened?

Hello,
I have a patcher with 16 sliders controlled by a MIDI controler (MIDI Fighter Twister) using the MIDI mapping feature (button on the bottom of the patcher). When I open the mappings window, all controls are there and all works well. 
But when I close my saved patcher and reopen it, the mapping does'nt work anymore, even though all controls are  still in the mappings window...
I precise that I saved the mapping to a file before saving my patcher, and closing it. 

Does anyone have an idea?

Is it the normal behavior of this feature? 
Can't the mapping be done once and for all so that it works properly each time the patcher is opened?

Hello,
I have a patcher with 16 sliders controlled by a MIDI controler (MIDI Fighter Twister) using the MIDI mapping feature (button on the 

Have to re-"Enable for mapping" each control at each launch of a patcher