Forums > MaxMSP

A patch to connect; motors, CUI32 and H-bridges?


GLC
September 21, 2010 | 11:40 am

Hi.
We are beginners and very unfamiliar with MaxMSP, so we hope some could help us a little in the right direction.
We need to connect MaxMSP to 3 motors via CUI32. We also need to use 3 H-bridges, because we need the motors to run forwards and backwards. So we guess we need a patch in MaxMSP that could turn the motors seperatly forwards and backwards? So some kind of on/off switch maybe? So on is for the motors to go right, and off is for the motors to go left? And then connect another on/off switch, that can switch all of the totally on and off?
Hope Some of you can help us out here, cause we don’t really know how to start the patch?


September 21, 2010 | 1:37 pm

Can I ask why you require MaxMSP to control the motors? Interactivity?

Brendan


Viewing 2 posts - 1 through 2 (of 2 total)