Forums > Jitter

amplitude control

June 14, 2007 | 9:50 am

is there somebody who has worked out more sophisticated amplitude control in jitter then tutorial 28 provides?


June 16, 2007 | 4:57 pm

does anyone know why the quality of a quicktime movie decays when using an operator?
I have a high quality quicktime film and use tutorial 28. When I view the output at full screen, I have a very bad quality left. Why?


June 16, 2007 | 5:02 pm

>does anyone know why the quality of a quicktime movie decays when
>using an operator?
>I have a high quality quicktime film and use tutorial 28. When I
>view the output at full screen, I have a very bad quality left. Why?

You haven’t turned on interpolation.

on the floor there’s a long wooden table/on the table there’s an open book/
on the page there’s a detailed drawing/and on the drawing is the name I took
Gregory Taylor http://www.rtqe.net


June 16, 2007 | 5:34 pm

Thanks for your reply Gregory. I would like to switch it on, but I can’t find it in Tutorial 28.
Cheers


June 16, 2007 | 5:46 pm

>Thanks for your reply Gregory. I would like to switch it on, but I
>can’t find it in Tutorial 28.

It’s covered earlier – page 120.

You can also check the jit.pwindow help file.


on the floor there’s a long wooden table/on the table there’s an open book/
on the page there’s a detailed drawing/and on the drawing is the name I took
Gregory Taylor http://www.rtqe.net


June 16, 2007 | 5:51 pm

>You can also check the jit.pwindow help file.

Make that jit.window, in this particular cast. You can use the same
message for both.

on the floor there’s a long wooden table/on the table there’s an open book/
on the page there’s a detailed drawing/and on the drawing is the name I took
Gregory Taylor http://www.rtqe.net


June 16, 2007 | 6:48 pm

Thanks, that’s mutch better. (I wish it could still interpolate more…)

cheers


Viewing 7 posts - 1 through 7 (of 7 total)