edsonedge

I am using maxuino an arduino mega, some pressure sensors hooked up to it, and Max msp

I get a reading in max from the pressure sensors: a float from 0. to 0.99

then i connect the floatBox to [if $i1 > 0.01 then out bang]

but when I press the pressure pad, even though the float box goes way up close to 1. I still get no bang from it

The wierd thing is that If I use the mouse to drive the same floatbox up it sends a bang

It seems like Max doesnt want to listen to the float box if it is connected to arduino

Here is an example of how this is connected

I am using maxuino an arduino mega, some pressure sensors hooked up to it, and Max  msp

I get a reading in max from the pressure sensors: a float from 0. to 0.99 

but when I press the pressure pad, even though the float box goes way up close to 1.    I still get no bang from it

It seems like Max doesnt want to listen to the float box if it is connected to  arduino

Here is an example of how this is connected


arduino-using-maxiuno-and-max-problem-with-analog-inputs

I haven't look at your patch, but the issue is probably that

you wrote [if $i1 > 0.01 then out bang] instead of [if $f1 > 0.01 then out bang].

Also, I personally prefer to write it that way : [> 0.01] -> [sel 1]

I haven't look at your patch, but the issue is probably that
you wrote [if $i1 > 0.01 then out bang] instead of [if $f1 > 0.01 then out bang].
Also, I personally prefer to write it that way : [> 0.01] -> [sel 1]
but it's maybe just a matter of taste :)


Arduino using Maxiuno and Max - problem with analog inputs