n871

I noticed in the ddg.mono help-patch (monophonic synth controller for virtual synths) that each time a key is released, ddg.mono outputs the note value again. I copied the patch below with a print object connected to ddg.mono's note output which proves this fact.

Is there a genius on this forum who could modify the patch, or help me modifying the patch so that nothing is outputted when a key is released. This would mean a huge help to me..

ddg-mono-patch-help-needed

sounds like you're looking for the object "stripnote"?

stripnote is used in combination with velocity. It deletes every zero.

My patch for many reasons works different. I don't use the velocity output (not for this part of the patch).

I just need the note output of ddg.mono stop outputting values when the key is released.

stripnote is used in combination with velocity. It deletes every zero.
My patch for many reasons works different. I don't use the velocity output (not for this part of the patch).
I just need the note output of ddg.mono stop outputting values when the key is released.

Possible? That's a silly question when dealing with max ;) Everything's more or less possible.

if the key is released then *velocity* is zero.

Cross over the pitch and velocity lines, go into a [gate] - velocities of non-zero will open the gate, zero will close it, blocking out the pitches.

if the key is released then *velocity* is zero. 

Cross over the pitch and velocity lines, go into a [gate] - velocities of non-zero will open the gate, zero will close it, blocking out the pitches.


nice :) thanks a lot!! ..wasn't too difficult in the end..

ddg.mono patch, help needed..