DaveFulham7@Hotmail.com

Ive been using the degrade~ object and all was working fine except that when I turn off DSP and then turn it back on again degrade~ ignores anything sent to the middle inlet. When the signal is unattached and reattached the middle inlet works again. This has happened before on other patches and ive been scratching my head and I can't work out why its doing this. Any ideas?

degrade-ignoring-middle-inlet-messages

Quote: DaveFulham7@Hotmail.com wrote on Fri, 04 May 2007 00:01

----------------------------------------------------

> Ive been using the degrade~ object and all was working fine except that when I turn off DSP and then turn it back on again degrade~ ignores anything sent to the middle inlet. When the signal is unattached and reattached the middle inlet works again. This has happened before on other patches and ive been scratching my head and I can't work out why its doing this. Any ideas?

I don't know why this happens in degrade~, but I use lp.nn~ instead. It doesn't have your problem and has the added advantage of supporting fractional bit-depths, so you can do a smooth sweep across quantization noise.

Quote: DaveFulham7@Hotmail.com wrote on Fri, 04 May 2007 00:01
----------------------------------------------------
> Ive been using the degrade~ object and all was working fine except that when I turn off DSP and then turn it back on again degrade~ ignores anything sent to the middle inlet. When the signal is unattached and reattached the middle inlet works again. This has happened before on other patches and ive been scratching my head and I can't work out why its doing this. Any ideas?
----------------------------------------------------

Degrade~ ignoring middle inlet messages