dsp status in standalone …

May 27, 2011 at 3:06pm

dsp status in standalone …

Hi there,

I’m using a specific I/O Audio Mapping in standalone mode (a pretty nice .exe)

The specific parameters “seems” to be stored (where?)
But, would not it be better to use an hardcoded setup with [adstatus] control ?

all tips would be very appreciate

#57325
May 28, 2011 at 12:35am

if you building a standalone that others may use then including a umenu that links to a adstatus input and output would be best. If its just for you then you can do a loadmess with the driver number into a adstatus.

Or you can forego all that and just add an open message into a exdac~ to open the dsp window.

GW

#205364
May 28, 2011 at 12:35am

if you building a standalone that others may use then including a umenu that links to a adstatus input and output would be best. If its just for you then you can do a loadmess with the driver number into a adstatus.

Or you can forego all that and just add an open message into a exdac~ to open the dsp window.

GW

#205450
May 28, 2011 at 8:10am

adstatus + hardcoded index number of interface & I/O mapping could fit well.

the main problem was the max preferences written on the standalone machine
I didn’t even know til know

#205365
May 28, 2011 at 8:10am

adstatus + hardcoded index number of interface & I/O mapping could fit well.

the main problem was the max preferences written on the standalone machine
I didn’t even know til know

#205452

You must be logged in to reply to this topic.