Sparky

I have a telepresence robot that uses WiFi to connect to a secure network through a MAX patch as a way of controlling the robot's onboard servo motors. There is a copy of the patch onboard the robot computer, as well as an identical copy on the control-booth computer. One is set to "master" and the other is "slave".

After I recently stripped the robot chassis down and rebuilt it, I am unable to get the patch to connect again. I have confirmed that the 2 computers are connecting to each other, and the local (onboard the robot) controls are working fine - just the connection between the 2 patches refuses.

I did not write this patch and I cannot dig down too deeply into MAX, but I have adjusted the ip settings, both in the computer control panel, as well as in the patch. I also tried rebooting, power cycling, etc.. and I have run out of ideas.

I must have this issue resolved before the Maker Faire this weekend, so I am in need of a Max expert who can help in any way.

I don't have alot of money, but I am willing to pay to get this resolved before the weekend.

A copy of the patch is enclosed. Please take a look. Thanks.

I have a telepresence robot that uses WiFi to connect to a secure network through a MAX patch as a way of controlling the robot's onboard servo motors.  There is a copy of the patch onboard the robot computer, as well as an identical copy on the control-booth computer.  One is set to "master" and the other is "slave".

After I recently stripped the robot chassis down and rebuilt it, I am unable to get the patch to connect again.  I have confirmed that the 2 computers are connecting to each other, and the local (onboard the robot) controls are working fine - just the connection between the 2 patches refuses.

I did not write this patch and I cannot dig down too deeply into MAX, but I have adjusted the ip settings, both in the computer control panel, as well as in the patch.  I also tried rebooting, power cycling, etc..  and I have run out of ideas.

A copy of the patch is enclosed.  Please take a look.  Thanks.

emergency-max-help-needed-before-maker-faire

Quote: Sparky wrote on Tue, 15 May 2007 09:25

----------------------------------------------------

> I have a telepresence robot that uses WiFi to connect to a secure network through a MAX patch as a way of controlling the robot's onboard servo motors. 

> A copy of the patch is enclosed. Please take a look. Thanks.

I can't open your patch. Could you copy it into a posting as text?

Quote: Sparky wrote on Tue, 15 May 2007 09:25
----------------------------------------------------
> Hi-
>
> I have a telepresence robot that uses WiFi to connect to a secure network through a MAX patch as a way of controlling the robot's onboard servo motors.  
> A copy of the patch is enclosed.  Please take a look.  Thanks.
>
> -Marque
> rust@marquecornblatt.com
----------------------------------------------------

I can't open your patch.  Could you copy it into a posting as text?

Emergency MAX help needed before MAKER FAIRE