Lasse Munk

I have a bit of trouble making the Enttec ODE working.

I have configured it using the NMU software as seen on the two attached files;

My ethernet ip in OSX 10.9 is 10.0.0.1 manual.

I use the DMX.IMP controller help patcher, to communicate (see copy compressed max patcher).

The status LED on the ODE is blinking rapidly as it says in the manual it should

The direction is lighting = it is set to transmit

the LINK is lighting; but when I send something from my max-patcher the LINK is blinking,

ACTIVITY is lighting, but does NOT blink when I send something from my max-patcher, and I don't get why ?

This means I does something wrong, right?

I also don't get DMX into my dimmer.. it's strange, as the dimmer is set to listen to channel 1.

I have configured it using the NMU software as seen on the two attached files; 

Enttec ODE:
IP: 10.0.0.2
Protocol: ArtNet
SubNet: 00 Universe: 00
Refresh Rate: Max

My ethernet ip in OSX 10.9 is 10.0.0.1 manual. 

The status LED on the ODE is blinking rapidly as it says in the manual it should
The direction is lighting = it is set to transmit
the LINK is lighting; but when I send something from my max-patcher the LINK is blinking,
ACTIVITY is lighting, but does NOT blink when I send something from my max-patcher, and I don't get why ? 

This means I does something wrong, right? 

I also don't get DMX into my dimmer.. it's strange, as the dimmer is set to listen to channel 1. 

ENTTEC OpenDmx Ethernet (ODE)