Forums > MaxMSP

Groove~ question

April 21, 2006 | 5:28 pm

hi All, it my be a stupid question but how can i make Groove~ read the Whole loop that i have stored in Buffer~? i want to get a solid loop going

thanks ,
joel


April 21, 2006 | 5:38 pm

groove~ can be a bit buggy with this, it dosen’t get the correct looptimes when it’s buffer~ is replaced. If you send a "set buffer" message to groove~ after replacing the buffer~ it will update….

The loop points for looping the whole file is 0. 0.


April 21, 2006 | 9:40 pm

Yes, its harder to read only a part… What did you do so far, beside
looking at the help file which as far as I know plays whole loops? You
might just need an info~ object to know the length of a buffer~….

Stefan

[][] [][][] [][] [][][]
[][][][][][][][][][][][][][][]

Stefan Tiedje
Klanggestalter
Electronic Composition
&
Improvisation

/~~~~~
\ /|() ()|
))))) )| | |( \
/// _/)/ )))))
___/ ///

————————-x—-
–_____———–|———–
–(_|_ —-|—–|—–()—-
– _|_)—-|—–()———–
———-()————x—–

14, Av. Pr. Franklin Roosevelt,
94320 Thiais, France
Phone at CCMIX +33-1-57 42 91 09


April 21, 2006 | 11:10 pm

exactly… just hook up info~ then have the "total time" set the loop end point.

jeremy


Viewing 4 posts - 1 through 4 (of 4 total)