Forums > MaxMSP

hi object help

January 28, 2007 | 3:31 pm

Basic Max question:

I’m trying to take the output of the hi object and separate out the
control messages (using the help file patch). Does anyone have a patch
that will do this that I can take a look at? I can see it only taking
one or two steps, but I’m drawing a blank.

Thanks!

charlieHUGE
_________________________
http://www.hugemultimedia.com
http://www.charlie-huguenard.com
http://www.massholemusic.com



a
January 28, 2007 | 8:16 pm

Don’t know if i understand the question but did you try "route"
object? Maybe it solves your separating problem.

hug,

Andr?

O


January 29, 2007 | 8:21 am

Check out the "spray" object. Hi outputs the number of the controller element and the value the element is sending as a list. Spray will send the element’s value out of the corresponding outlet. Of course route works too….just needs more arguments (i.e. more to type). :)

Quote: charlie wrote on Sun, 28 January 2007 07:31
—————————————————-
> Basic Max question:
>
> I’m trying to take the output of the hi object and separate out the
> control messages (using the help file patch). Does anyone have a patch
> that will do this that I can take a look at? I can see it only taking
> one or two steps, but I’m drawing a blank.
>
> Thanks!
> —
> charlieHUGE
> _________________________
> http://www.hugemultimedia.com
> http://www.charlie-huguenard.com
> http://www.massholemusic.com
>
—————————————————-


Viewing 3 posts - 1 through 3 (of 3 total)