Forums > MaxMSP

Maxuino Analogue out

March 4, 2012 | 2:08 pm

Hi everyone, I was wondering if there was anyone who knew how to send an analogue signal out from maxuino. I am using an uno and I basically want to turn L.E.D.s on and off from max… I have changed the pins I am using in the analogue section to the right numbers but cannot figure out a way to send out – the examples all seem to be analogue sensors in and digital out.

Any help would be greatly appreciated!
Thanks in advance
Nick


March 4, 2012 | 2:46 pm

That’s because instead of sending analogue out, you use PWM with your digital outs.

Check it out:

http://arduino.cc/it/Tutorial/PWM

EDIT: I may have misunderstood what it was you were trying to achieve. Digital outs have two states: on (1) or off (0), which is suitable for turning LEDs on or off. Alongside this ‘toggle’ functionality, you can modulate between the two states to simulate analogue values.


Viewing 2 posts - 1 through 2 (of 2 total)