Miditron – Help connecting sensors


Anonymous

Anonymous
Jan 2, 2008 at 7:26am

hello,

I have recently purchased a miditron and am wondering if any forum members could help me out some images (step-by-step) and instructions on connecting sensors. Temperature and Photo.

Thanks

Also, is this the right section?

#35178
Jan 2, 2008 at 6:10pm

If you’re new to the subject, your best destinations are the web site
and the book “Physical Computing” by Dan O’Sullivan and Tom Igoe.

Eric

At 12:26 AM -0700 1/2/08, Tom Hall wrote:
>hello,
>
>I have recently purchased a miditron and am wondering if any forum
>members could point me towards some images (step-by-step) and
>instructions on connecting sensors. Temperature and Photo.
>
>Thanks
>
>Also, is this the right section?
>
>
>

#119519
Jan 3, 2008 at 2:59am

You might check out the tutorials for the Arduino, Make controller, and wiring board’s tutorials. I’m assuming that the miditron works with voltages in the 0-5 volts range, but the circuits should be similar. Here are some links to other controllers and how sensors and motors are hooked up to them. Some info may be helpful, some may not and be board specific.

http://www.wiring.org.co/learning/tutorials/index.html
http://www.makingthings.com/documentation/how-to

http://www.arduino.cc/playground/Main/InterfacingWithHardware

you may want to look at pages 14-19 of the miditron manuals too.

http://www.eroktronix.com/docspecs.html

#119520

Anonymous

Anonymous
Jan 4, 2008 at 1:18am

Thanks for the info to date. It’s very useful.

Just wondering if anyone has any info/hookup images for the miditron other than the manual it’s supplied with?

cheers!

#119521
Jan 10, 2008 at 2:48am

#119522

You must be logged in to reply to this topic.