Chris Muir

While working on an example for the "Handling output of many sliders/ 

dials" thread, I noticed a problem with using zl compare and zl mth to 

extract changes. The problem is that zl compare will output lists if 

more than one slider changes at a time. The technique shown in the 

multislider help file fails in this case.

Here is a patch that shows the problem, and implements a solution to 

While working on an example for the "Handling output of many sliders/ 
dials" thread, I noticed a problem with using zl compare and zl mth to  
extract changes. The problem is that zl compare will output lists if  
more than one slider changes at a time. The technique shown in the  
multislider help file fails in this case.

Here is a patch that shows the problem, and implements a solution to  
iterate over the change list.

Chris Muir
cbm@well.com	
http://www.xfade.com

multislider-zl-change-issue

Thanks Chris! I've been working all day on a multislider sequencer for myself and this is the last step I was going to put into place; will definitely use your solution.

On Aug 6, 2008, at 3:30 AM, Emmanuel Jourdan wrote:

> Here is a slightly modified version with a fewer objects using the 

These are both educational, and good to see, but all the same amount 

of objects (once you factor out the index/data display integers)

> Here is a slightly modified version with a fewer objects using the  
> new lookup and lace modes.

These are both educational, and good to see, but all the same amount  
of objects (once you factor out the index/data display integers)

multislider zl change issue