CarpentersKeys

So I was making some modifications to the midi processing portion of my patch lately but nothing really in the audio rate realm but suddenly the sampler is arbitrarily affecting the playback rate.

Time, rows, playback start/end loop on the x coord are accounted for in the rate of the phasor~ reading the 2d.wave~ object.

As best I can describe the problem, since I'm using a launchpad the smallest selection I can make (by press two buttons in a column to choose the looping selection) is a quarter of the samples length but these can start and end offset by an eighth of the length.

When selecting the full sample playback the rate is normal. When selection the top most quarter down through the the 3rd offset position the pitch is slightly increased. Following that theres one quarter at the halfway that is a lower pitch. Then it returns to the higher pitch until the last possible selection which is an even lower pitch.

I feel like I did nothing to instigate this bug in my patch and I'm usually playing casually while I make changes so I can notice a breakage like that. I have a gig in, like, 7 hours and I need to sort this out stat.

Any suggestions would help because honestly as far as I can tell all parameters affecting the 2d.wave~ should be fine (signal from phasor~/looping/rows).

When selecting the full sample playback the rate is normal. When selection the top most quarter down through the the 3rd offset position the pitch is slightly increased. Following that theres one quarter at the halfway that is a lower pitch. Then it returns to the higher pitch until the last possible selection which is an even lower pitch. 

mystery-2d-wave-playback-issues

I rewire to Renoise and the sampling rate in max was at 48000 and renoise was in 41000 or vice versa and the samples are render at 41000.

Mystery 2d.wave~ playback issues