Nov 18, 2010 at 11:23pm


Hi, am receiving an OSC signal and wish to translate this to MIDI.

Anyone had any experience doing this? Sure it is not too tricky, but have not found much info out there on it yet.

Nov 19, 2010 at 12:37am

numbers to numbers, just see what range you get in and map it with [scale] or similar to make MIDI notes, CC changes, etc…

experiment for awhile, you’ll get some good ideas. you might also need [change] to filter repetitions, if your incoming signal comes in rapidly, you may not want to create all those noteons unless something changes enough to warrant a new note :)

you can also use an [itable] to do more sophisticated (and presettable) mappings of your input (OSC) to your output (MIDI).


You must be logged in to reply to this topic.