Phijel

i was wondering if the following patch is a good way to sync two oscillators

I'm wondering this because i suppose the [edge~] banging is not happening at signal rate ?, and on the other hand, the [phasor~] phase input doesn't accept signals....

oscillators-sync

Phijel wrote on Sun, 22 February 2009 15:45

Phijel wrote on Sun, 22 February 2009 15:45Hello

Thanks, but in fact i only want to have the option for the slave oscillator to reset its phase when the master Osc starts a new cycle, but allow them to run out of phase between every retrigger (both osc are driven by a [phasor~] at its own, and maybe different, frequency).

I don't see how to do this with [rate~], because then,if i understand correctly, the frequency of the slave will always be a multiple of the master frequency ?

Thanks, but in fact i only want to have the option for the slave oscillator to reset its phase when the master Osc starts a new cycle, but allow them to run out of phase between every retrigger (both osc are driven by a [phasor~] at its own, and maybe different, frequency). 

Have a look at examples/synths/oscsync-advanced

Have a look at examples/synths/oscsync-advanced
cheers
Roger


exactly what i was looking for... thanks


oscillators sync