Forums > MaxMSP

Output to Digital Performer

May 9, 2006 | 9:25 pm

I recently started using DP, and I noticed I can assign pairs of Max/MSP outputs as stereo-bundle inputs in DP (starting with 1/2, going to 15/16). However, I tried each of the pairs and none sent a signal from MSP to DP. Do I need to set up an output object other than dac~ to route the signal into DP, or change a configuration in MSP or DP? Thanks in advance for any help.


May 10, 2006 | 12:00 am

Use soundflower soundflowerbed etc… to ping pong with MSP be
carefull to feed back.
But in fact i don’t know what’s about those MSP ins and outs i have
in my DP to
If anyone knows???
Hubert


May 10, 2006 | 12:17 am

These are Rewire channels.
In order to make use of these, switch the MaxMSP audio driver to
ad_rewire in the DSP Status window.


May 10, 2006 | 3:40 am

Make sure you are in rewire mode in the DSP Status. Also in DP you must be
in record enable with input monitoring on. Also in DP in your hardware input
monitoring pref, make sure you are at "always" play thru….

best


Viewing 4 posts - 1 through 4 (of 4 total)