misteron

I'm learning Max with the 30 day demo of Max/MSP/Jitter. 

In tutorial 7 it says the following but none the less outputs values of 0-5-10-15 etc:

"When you move the sliders, you might be surprised by some of the interim values that you see. For example, rather than seeing 0-5-10-15 for the first four values, you will see 0-4-9-14"

If this is a mistake in how the example patch was set up, then what set up would give such results?

Hi all, first post.
I'm learning Max with the 30 day demo of Max/MSP/Jitter. 
In tutorial 7 it says the following but none the less outputs values of 0-5-10-15 etc:

If this is a mistake in how the example patch was set up, then what set up would give such results? 

question-re-tutorial-7

When I enter "5" into the number box connected to the multiplier message I get 0-5-10-15.

I did notice, however, that when I start to adjust the number box connected to the size message Max 5 crashes. I attached the OS X crash report.

On 22 janv. 09, at 05:31, David Huff wrote:

> When I enter "5" into the number box connected to the multiplier 

> I did notice, however, that when I start to adjust the number box 

> connected to the size message Max 5 crashes. I attached the OS X 

Thanks this was already fixed for the next incremental. In the 

meantime, try not to ask for a range of 1 with dial.

> When I enter "5" into the number box connected to the multiplier  
> message I get 0-5-10-15.

> I did notice, however, that when I start to adjust the number box  
> connected to the size message Max 5 crashes. I attached the OS X  
> crash report.

Thanks this was already fixed for the next incremental. In the  
meantime, try not to ask for a range of 1 with dial.

question re tutorial 7