Forums > MaxMSP

Rewire Reason/Max Problem! Re: Loop Function

December 27, 2009 | 11:36 pm

Hello there

I am rewiring Reason with MaxMSP and all is well except that the loop function is not working, despite the fact that I have successfully setup and initiated the loop start and end points on the transport bar and the loop light is on, however for some reason the playhead just skips the loop point without returning to the begining!

Any ideas why this is happening?

Would really appreciate any help.

Thanks
Sam


December 28, 2009 | 6:44 pm

Any ideas at all?

Has anyone managed to program a loop without this issue?


December 28, 2009 | 8:15 pm

Probably going to need to post an example patch to give us a better idea of what you’re after.


December 29, 2009 | 1:45 am

Hey thanks for the reply.

I have basically recreated the patch outlined here:

http://cycling74.com/2006/12/15/rewire-essentials-part-two/

…specifically ‘rewire~ test patch 3′ about half way down the page.

The loop message going to the rewire object is working visually, but for whatever reason, the Reason 4 sequencer is ignoring the loop that is clearly enabled in the transpot bar.

In addition, after doing a search of the forum it seems others have had a similar issue

http://cycling74.com/forums/topic.php?id=5416#post-28124

so perhaps it is not resolvable at present?

Sam


Viewing 4 posts - 1 through 4 (of 4 total)