Forums > MaxMSP

scrubbing/scratching audio using a slider and wave~

May 20, 2011 | 4:44 pm

Hi guys,

I’m sure this must have been covered somewhere, but I can’t find it.

I want to read through a buffer using the wave~ object (because that is what I’m already using in my patch) by taking a slider with a scale of 0-1, and converting that into a signal. I would have thought that this should work…

I’ve tried going from the slider to both the sig~ and line~ objects and then into the wave~ object. Signal produces no sound and line just creates horrible clicks.

My reason for wanting to do this is that I have a sampler that I can use to record, skip around, reverse etc using transport, phasor~, rate~, and wave~, but I want to be able to grab the audio and scrub through it using a slider. As if I’m scratching on a turntable.

Is it possible? I don’t want to waste my time exploring this if it cant be done…

Thanks for any advice you can offer.

Best,
Christian


May 24, 2011 | 5:24 pm

Post a patch.


May 24, 2011 | 5:55 pm

it can be done yes,

there was a thread about this a few months (maybe a year?) back

search the forum


Viewing 3 posts - 1 through 3 (of 3 total)