dondelion

I'm making a signal rate sequencer where the sequence is created via a multislider and stored in a buffer~. The buffer~ is read by wave~ and used to modulate rate~ which then drive a zigzag~. This signal then drives play~ and is again modulated by another wave~. 

My method appears to allow samples to be triggered on any beat and they play until retriggered. Problems are arising when I change the beat length and the buffer~ is repopulated from the multislider.

Everything is driven by the same phasor~ yet still doesn't appear to have locked together. Any suggestions as to where I am going wrong would be very helpful...

I'm making a signal rate sequencer where the sequence is created via a multislider and stored in a buffer~. The buffer~ is read by wave~ and used to modulate rate~ which then drive a zigzag~. This signal then drives play~ and is again modulated by another wave~. 
My method appears to allow samples to be triggered on any beat and they play until retriggered. Problems are arising when I change the beat length and the buffer~ is repopulated from the multislider.
Everything is driven by the same phasor~ yet still doesn't appear to have locked together. Any suggestions as to where I am going wrong would be very helpful...

signal-rate-sampler-problems

i just tried it out, everything appears to be lined up to me. i tried 

changing the beat lengths for both samples and couldn't hear any 

problems. how bad was the problem that you were hearing?

> I'm making a signal rate sequencer where the sequence is created via a multislider and stored in a buffer~. The buffer~ is read by wave~ and used to modulate rate~ which then drive a zigzag~. This signal then drives play~ and is again modulated by another wave~. 

> My method appears to allow samples to be triggered on any beat and they play until retriggered. Problems are arising when I change the beat length and the buffer~ is repopulated from the multislider.

> Everything is driven by the same phasor~ yet still doesn't appear to have locked together. Any suggestions as to where I am going wrong would be very helpful...

i just tried it out, everything appears to be lined up to me. i tried 
changing the beat lengths for both samples and couldn't hear any 
problems. how bad was the problem that you were hearing?

donovan sellings wrote:
> Hey list,
>
> I'm making a signal rate sequencer where the sequence is created via a multislider and stored in a buffer~. The buffer~ is read by wave~ and used to modulate rate~ which then drive a zigzag~. This signal then drives play~ and is again modulated by another wave~. 
> My method appears to allow samples to be triggered on any beat and they play until retriggered. Problems are arising when I change the beat length and the buffer~ is repopulated from the multislider.
> Everything is driven by the same phasor~ yet still doesn't appear to have locked together. Any suggestions as to where I am going wrong would be very helpful...
>
> Thanks as always,
>
> Don
>
>


Really? I've tried it on 2 machines and if I play the default pattern (1st note only) and change the number of beats on either sampler, the samples aren't in time. They appear to go out of time by 1 beat division and I can't see why...grrr. Thanks for looking...

Is my setup unnecessarily complicated? Is there an easier way to drive a sampler at signal rate?

signal rate sampler problems