jazzisfaction

I post the patcher in question but i think it is too complicated to post it (it's the inside of a poly~).

So i have this groove~ object (inside a poly) and I take a snapshot at the right outlet.

In normal mode everything works fine and snapshot counts from 0. to 1. but if I go in reverse mode, snapshot jumps directly to a 1. or 0. or -0. in place of counting down.

Does anybody have experience with that? What could be the problem?

Hey,
one of these days.
I post the patcher in question but i think it is too complicated to post it (it's the inside of a poly~).
So i have this groove~ object  (inside a poly) and I take a snapshot at the right outlet.
In normal mode everything works fine and snapshot counts from 0. to 1. but if I go in reverse mode, snapshot jumps directly to a 1. or 0. or -0. in place of counting down.
Does anybody have experience with that? What could be the problem?
Every little hint if welcome.
Cheers
Peer


snapshot reverse