|
|
Nov 24, 2010 at 3:43pm
Toggle object + push to make switch.
Hi,
I have a push to make switch hooked up to a max msp patch, now when i hold down the switch, the toggle object turns on (with the X), but it only stays that way while i have it held.
Is there anyway, within max msp, that i can set it so that i press the switch and it stays on, and i press it again and it goes off?
thanks
bk
|
|
|
Nov 24, 2010 at 6:15pm
sounds like you need a select…
Copy all of the following text.Then, in Max, select New From Clipboard.
----------begin_max5_patcher----------
297.3ocuRErZCCCC8ryWgwmyBNt0PausuiQY3j3k5gibH1gksR+2WriyVaIk
UnvtHgdRVu2S3iIHRgYPZI3c3WvHzwDDJ.4APwZDoQLTpE1vXDP9go3cR5TK
mbvEfsRMNeFE5aTfV5BufEAaEtxCJn90NYoahQFcUFMEmy49zJVFerXSFEuO
9FUUX4iD9Ded4uY.GHZjgNO2oD5yn0z6tl2IH2msxIRIEBnljhIjenwuRq5q
v.4zLpG8TRhOjdmmEmotVKW7.j+mG.FciOw2NGW5.rdYaleKapfQR1+eaksQ
CMGWxIrG0IgkRzJ35utAc4wuzdVSeW471helv+JsJo0o.gSYfylY8EybPUUI
CsoQjFUUqYTZQIbiS88pH1cnH9CnnwhSIeyDzatW
-----------end_max5_patcher-----------
|
|
|
Nov 24, 2010 at 8:56pm
its always the simplest of answers :)
thanks so much!
bk
|
