Toggle switch using MIDI keyboard

Nov 17, 2006 at 1:40am

Toggle switch using MIDI keyboard

I’m trying to setup a toggle switch that would be controlled from MIDI keyboard. So if I press a certain key the switch would be switched on, and if I press the same key again it would switch off.

I came very close using [noetin]->[select 54]->[Ggate]

When note with pitch 54 is pressed select sends a bang out to Ggate which changes the output, but the problem is that when I depress the key the value 54 is sent once again with note-off message, and select sends another bang which toggles the Ggate back to the first output.

So in my example due to this the effect is active only while I hold the MIDI key and deactivated as soon as I depress it, but I would like it to stay on till the next time I press the same MIDI key.
Any solutions/suggestions would be greatly appreciated.

#28743
Nov 17, 2006 at 2:22am

Use ‘stripnote’ after the notein and before the select – it removes
noteoffs (noteons with a velocity of 0).

On Nov 16, 2006, at 6:41 PM, Jernej Marusic wrote:

>
> I’m trying to setup a toggle switch that would be controlled from
> MIDI keyboard. So if I press a certain key the switch would be
> switched on, and if I press the same key again it would switch off.
>
> I came very close using [noetin]->[select 54]->[Ggate]
>

—-
Steven M. Miller

Associate Professor of Contemporary Music
College of Santa Fe
Contemporary Music Program
1600 St. Michaels Drive
Santa Fe NM 87505
http://pubweb.csf.edu/~smill
(505) 473-6197

SFIFEM Atrium Sound Space OVOS
http://sfifem.csf.edu http://atrium.csf.edu http://pubweb.csf.edu/
~smill/ovos.html

—-
Steven M. Miller

Associate Professor of Contemporary Music
College of Santa Fe
Contemporary Music Program
1600 St. Michaels Drive
Santa Fe NM 87505
http://pubweb.csf.edu/~smill
(505) 473-6197

SFIFEM Atrium Sound Space OVOS
http://sfifem.csf.edu http://atrium.csf.edu http://pubweb.csf.edu/
~smill/ovos.html

#88561
Nov 17, 2006 at 5:19pm

Thanks a lot, ‘stripnote’ did the trick

#88562

You must be logged in to reply to this topic.