Forums > MaxMSP

[troubleshooting] msp object works only once per restarting the program

March 27, 2007 | 7:29 pm

Dear list,
After authorizing Max/Msp + Jitter … msp does’nt properly work.
take this simple example:

when I hit start it generates sound. The second time (after I stop it
once) there is no
sound generated unless unless I restart max/msp program and then
again it runs only
once. Any help is appreciated .
d.


March 27, 2007 | 7:37 pm

Begin forwarded message:

> From: Dean
> Date: March 27, 2007 3:29:30 PM EDT
> Subject: [troubleshooting] msp object works only once per
> restarting the program
>
> Dear list,
> After authorizing Max/Msp + Jitter … msp does’nt properly work.
> take this simple example:
>
>
>
>

> when I hit start it generates sound. The second time (after I stop
> it once) there is no
> sound generated unless unless I restart max/msp program and then
> again it runs only
> once. Any help is appreciated .
> Dean.



jln
March 28, 2007 | 10:01 am


March 28, 2007 | 10:16 am


March 28, 2007 | 4:57 pm

I once had this problem on a G4 PowerBook with the system clock set incorrectly. DSP would only run until the dsp was recompiled (for example restarting audio or creating a new msp object) and then the program would produce no audio.

I’m not saying that’s the problem in this case, as you given hardly any info about your setup, but worth a check that your system date is set correctly.

Regards,

Alex


March 28, 2007 | 10:28 pm


Viewing 6 posts - 1 through 6 (of 6 total)