Richardo P

Please excuse all the terrible technical wording im about to make, coding of all forms is completly new to me even this very visual form.

Im am looking to track sound to effect the loop points of a movie (heh you may have seen this before). Ive read through tutorial 28 and I think I have a moderate grasp of peakamp and the event detection that provides the input for jit.op. I've also read a little about the sub patches used in the tutorial.

However I am not looking to track notes or events just the amount of sound (Volume). My sound input will be a microphone in a room that will either be empty or full of people (more people hopefully =more noise = a different loop point on the movie is set.

I assume this means replacing peakamp~ with soemthing else and then removing the event and note detection completly that is the screens and objects in the lower right of the tutorial

Im am looking to track sound to effect the loop points of a movie (heh you may have seen this before).  Ive read through tutorial 28 and I think I have a moderate grasp of peakamp and the event detection that provides the input for jit.op.  I've also read a little about the sub patches used in the tutorial.

However I am not looking to track notes or events just the amount of sound (Volume).  My sound input will be a microphone in a room that will either be empty or full of people (more people hopefully =more noise = a different loop point on the movie is set.

what do i replace peakamp~ with
are my assumptions correct

which-sound-settings

heh, so its taken me a few days to realise how stupid this question was

Thanks anyway, for not ridiculing me i guess lol

Which sound settings