Paolo Piaser

I am experiencing a problem with fold in gen~. If I set feedback values larger than 1.01, the fold object seems to not work anymore.

Is this expected behaviour or found a bug?

flonum

message

number~

cycle~

gen~

fold

I am experiencing a problem with fold in gen~. If I set feedback values larger than 1.01, the fold object seems to not work anymore. 

Is this expected behaviour or found a bug? 

Hello,
I am experiencing a problem with fold in gen~. If I set feedback values larger than 1.01, the fold object seems to not work anymore. 

"fold"-behaviour

If you wish to use the fold operator with non-vanilla ranges, you'll need to specify them as arguments (e.g fold 0 1.01).

I think I did that. I set "fold -1 1", so it should work, but it doesn't on my side. If I set the feedback > 1, sooner or later the system will "explode" ignoring the fold

"Fold" behaviour