Filtering a control signal without affecting the output.


    Oct 14 2013 | 2:28 pm
    Hello,
    I am building a simple mono pan control and would like the control signal coming from the pan control to be filtered to avoid any pops or clicks when panning. I have had no luck so far and anyway of filtering that I have tried has affected the main output signal. The pan is built with two signal routes coming out from the left of the plug in with a multiply box on each, these then exit via the L/R of the plug out. The pan control signal is coming in on the other inlet of the multiply boxes. Does anyone have a way to do this?
    Thanks.

    • Oct 14 2013 | 5:02 pm
      Can you post your code? Usually the pops and clicks are the result of not interpolating.
    • Oct 14 2013 | 7:57 pm
      Yeah interpolating was the needed fix. This has been achieved thanks.