Mark D.

I'm pretty new to Max still, which you'll be able to tell quickly from viewing the patch, but I did my best at emulating a Mutronics Mutator for my Owl Pedal. I used the Moogladder example for the filter, since I couldn't find any good documentation on how to build one in Gen, and I have no idea how to see how the example was made outside of "require Moogladder". I tried to tailor the knob scaling in the patch as close to my actual unit as possible. Still have to figure out which knobs to limit though since the Owl only has 4 and an expression.

In the meantime, it's pretty messy in there and could probably be done much more efficiently and authentically. Take a look and tell me if you see anything I could improve.

playlist~

message

ezadc~

prepend

dial

toggle

inlet

outlet

ezdac~

gen~

comment

triangle

slide

phasor

clip

param

codebox

button

I'm pretty new to Max still, which you'll be able to tell quickly from viewing the patch, but I did my best at emulating a Mutronics Mutator

made-an-emulation-of-a-mutronics-mutator-in-gen

I decided that the push button would route the knobs to alternate parameters so you can access everything.

Problem: I used latch objects to hold the last knob value when you press the push button, but they all change to the new positions when you press it again. I can't figure out an efficient way of holding the latched value until you move the knob again (as if a bunch of latch objects were efficient in the first place).

Looks a bit nicer now. 

I decided that the push button would route the knobs to alternate parameters so you can access everything. 

Okay, so I devised a way to do it using history, not sure how efficient that is, but it's the best I could come up with. Play around with it and again, suggestions for improvement is always welcome!

Made an emulation of a Mutronics Mutator in Gen