Roman Thilenius

i might change that in an older project, but wonder two things.

 object - when it multiplies the incoming signal with a factor lower than 1 - know when my (resettable) phasor has been restarted? wouldnt it count wrong internally?

- how will it know where to start when it was turned dsp-off or disabled ?


until now i was always using 

*~
%~

instead of

rate~

for more flexibility.

i might change that in an older project, but wonder two things.

 - how can a rate~ object  - when it multiplies the incoming signal with a factor lower than 1 - know  when my (resettable) phasor has been restarted? wouldnt it count wrong internally?

 - how will it know where to start when it was turned dsp-off or disabled ?




until now i was always using 

*~
%~

instead of

rate~

for more flexibility.

i might change that in an older project, but wonder two thi

rate-"reset"

Just had the exact same thought, I usually use a modulo and multiplication, and a plus for setting phase in my gen~ projects, but realised I cannot generate frequency below the base range of 0 - 1.

rate "reset"