cnam

I was hoping to get some guidance in how to create a panner for a drum machine I've built.

The drum machine has 6 modules that can load 6 different drum samples. I would like to find a way to include a pan knob in each module.

Any guidance or suggested tutorials would be so helpful.

I was hoping to get some guidance in how to create a panner for a drum machine I've built.
The drum machine has 6 modules that can load 6 different drum samples. I would like to find a way to include a pan knob in each module.

creating-a-panner

This is the patch I am currently work with as my master trigger for the drum machine.

could you check if you have [m4l.pan1~]? That's a goodun'.

i did manage to find that patch. no I'm just not sure what to do with it.

if I send you my patch would you be able to offer guidance?

i did manage to find that patch. no I'm just not sure what to do with it.
if I send you my patch would you be able to offer guidance?


thank you so much, wetterberg. I appreciate any guidance in this!

well the panner just goes after your monoOut, really. I'd use live.gain~ after the panners.

I don't think I did this correctly. Wetterberg, would you mind looking this over?

I don't think I did this correctly. Wetterberg, would you mind looking this over?
I appreciate your help!


So you hooked up the panner, but only hooked up the left output.

A panner has one input, two outputs. you used m4l.gain1~ instead of live.gain~, as I suggested.

Creating a panner