Dorothy Hindman

Any way to convert frequencies to pitches to the nearest quarter tone in Max?

frequency-pitch

Perhaps you'd find the "pitch detection" tab for the retune~ help file to be one place to start.

Hz
[ftom]
[* 2.]
[round]
[* 0.5]
nearest quarter tone


I'm looking for the actual name of the pitch, as in C or B, rather than the midi note number. Thanks for the help so far. Will check out the retune object.

I'm looking for the actual name of the pitch, as in C or B, rather than the midi note number.  Thanks for the help so far.  Will check out the retune object.


I don't seem to have the retune~ object?


>I don’t seem to have the retune~ object?

>I’m looking for the actual name of the pitch, as in C or B, rather than the midi note number.

Max supports converting from a midi pitch into whatever you want it to be called. There are no turnkey solutions to anything, though.

>I don’t seem to have the retune~ object?
Then you're not in max7.

>I’m looking for the actual name of the pitch, as in C or B, rather than the midi note number.
Max supports converting from a midi pitch into whatever you want it to be called. There are no turnkey solutions to anything, though.


[% 12] will get you the note degree. Then just translate that to pitches using a dict or coll something else.

going to spend some time with retune~ see if that is any more accurate.

(look in the inspector of the integer box > appearance > display format .. you can change it to display midi pitch after you convert ftom.

i just did it in 2 minutes using fzero~.
going to spend some time with retune~ see if that is any more accurate.

(look in the inspector of the integer box > appearance > display format .. you can change it to display  midi pitch after you convert ftom.


Did the OP say she was trying to pitch track incoming audio?

If you just want to show MIDI pitch names then the number box object set to "MIDI" in the "format" portion of the Inspector is the way to go.

Did the OP say she was trying to pitch track incoming audio? 

If you just want to show MIDI pitch names then the number box object set to "MIDI" in the "format" portion of the Inspector is the way to go.


the original question assumes pitch tracking.

the original question  assumes pitch tracking.


@Wil - "the original question assumes pitch tracking."

No it doesn't. If you read it literally, which you should, he just wants to translate frequencies in Hz, to note names. No mention of pitch tracking. Assuming anything on the internet is a bad practice.

@Wil - "the original question  assumes pitch tracking." 

No it doesn't. If you read it literally, which you should, he just wants to translate frequencies in Hz, to note names. No mention of pitch tracking. Assuming anything on the internet is a bad practice.


@Evan . please don't be condescending. you could have offered an alternative solution that proves why converting hz to pitch name might be necessary without an incoming signal like for giving an exam for class or to make some sort of reference chart.

frequency to pitch