lyallmarcus

I'm trying to grab video using jit.qt.grab through my decklink extreme video card.

I'm inputting through plain old composite.

I set the vdevlist and inputlist to the right settings, but I just get the 'Blackmagic Design - no video input detected' screen in the digitiser window.

Hmm. So I try inputting the same source using the firewire connector. I get the SAME blackmagic screen, even though I'm not using that device to capture, I'm using the internal firewire port.

So then I try the same thing is Final Cut Pro. Both firewire and composite ports are functioning as normal.

At some stage in the past this setup worked fine. Since then I've upgraded Jitter and the Blackmagic driver.

Has anything changed in the Jitter code that would make this stop working?

I'm trying to grab video using jit.qt.grab through my decklink extreme video card. 

jit-qt-grab-and-decklink-problems

There haven't been any Jitter changes which should lead to this. If 

you check the input list, can you select a different input? There 

might be some driver specific or QT specific preferences that have 

There haven't been any Jitter changes which should lead to this. If  
you check the input list, can you select a different input? There  
might be some driver specific or QT specific preferences that have  
led to this.

jit.qt.grab and decklink problems