Forums > MIRA

live.meter not working


August 25, 2013 | 4:40 am

It shows up on the ipad but that’s all…

September 30, 2013 | 9:10 am

Hello !
Anyone ? Is there a new version of mira that i would have missed ?

September 30, 2013 | 9:20 am

Well, it appears that live.meter is still not supported…
meter~’s display is so slow… how would you do to properly display the level of a track ?

October 1, 2013 | 1:50 am

Noticed that since the launching of Mira. Like you, expected more news.

October 1, 2013 | 11:09 am

you can make a meter from a (peakamp~ 25) (25 is the refresh rate)

on its output connect a (slider)

slider inspector
float output tick yes.
mode absolute
range 1
output min 0
output multi 1

the slider will bounce up n down to the signal you feed into peakamp.

October 1, 2013 | 11:12 am

to add, probably a bit obvious but worth mentioning: have you tried lowering meters~ refresh interval in inspector?

October 2, 2013 | 2:59 am

Thank you for pointing this technique, that’s clever.

October 2, 2013 | 11:36 pm

That won’t change the fact the live.observer is slow at outputting values…

October 3, 2013 | 1:33 am

Yeah, using udpsend seems to be the most accurate way.

Viewing 9 posts - 1 through 9 (of 9 total)