KinoLab

When i try the digitals outputs trough the maxduino test everything work, but when i put a bang to pilote a digital output, it dosen't work, the Led light on but not the connections.

When i try to verify the Firmata it tell me :

Hi, i've a problem with maxduino.
When i try the digitals outputs trough the maxduino test everything work, but when i put a bang to pilote a digital output, it dosen't work, the Led light on but not the connections.

problem-maxduino

"When i try the digitals outputs trough the maxduino test everything work"

" but when i put a bang to pilote a digital output, it dosen't work"

there is a firmware included in the maxuino zip if i remember rightly, you have to take that file and replace it in the arduino folder so that the standard firmita is updated.

also you have to go into the prefrences of maxmsp and somewhere in there is a tab that allows you to point to the arduino folder. (browse and select the arduino or maxuino folder? not sure which)

its been a while since i used it but i had these few problems , also i had to select COM1 as my port for connection to the arduino , i had to selct it a few times to make it wake up.

but once it all worked it was o.k. latency is pretty poor i found, but that might just be the way i had it set up.?

maxuino can trigger a digital out , via the

have you changed the prefrences in maxmsp, so

there is a firmware included in the maxuino zip if i remember rightly, you have to take that file and replace it in the arduino folder so that the standard firmita is updated. 

also you have to go into the prefrences of maxmsp and somewhere in there is a tab that allows you to point to the arduino folder. (browse and select the arduino or maxuino folder? not sure which) 

its been a while since i used it but i had these few problems , also i had to select COM1 as my port for connection to the arduino , i had to selct it a few times to make it wake up.  

maxuino can trigger a digital out , via the 

have you changed the prefrences in maxmsp, so


Problem Maxduino