Guillaume Bertrand

jit.gl.cornerpin is great, but cornerpins can be hard to control precisely sometimes.

Here is a little interface I often use to manipulate cornerpins.

Pretty convienient when the corners are out of reach.

It uses a set of motors to increment the corner positions.

I did not implement all the movements possible, you'll easily make knew ones using the same principle.

jit.gl.cornerpin is great, but cornerpins can be hard to control precisely sometimes.
Here is a little interface I often use to manipulate cornerpins.
Pretty convienient when the corners are out of reach.
It uses a set of motors to increment the corner positions.

I did not implement all the movements possible, you'll easily make knew ones using the same principle.
Hope you'll find it usefull.

sharing-cornerpin-convenient-manipulation

perhaps you'd consider submitting this to the Toolbox?

hi guillaume. this is wicked cool!
perhaps you'd consider submitting this to the Toolbox?


Thank you, Rob, but I think it's a little bit too "drafty" to be published to the toolbox !

This is very usefull, and the use of "sw" is great !

Thanks for sharing !
This is very usefull, and the use of "sw" is great !


[Sharing] jit.gl.cornerpin convenient manipulation