ddg.mono patch, help needed..


    Oct 24 2013 | 8:36 pm
    Hello,
    I noticed in the ddg.mono help-patch (monophonic synth controller for virtual synths) that each time a key is released, ddg.mono outputs the note value again. I copied the patch below with a print object connected to ddg.mono's note output which proves this fact.
    Is there a genius on this forum who could modify the patch, or help me modifying the patch so that nothing is outputted when a key is released. This would mean a huge help to me..
    thank you! : )

    • Oct 24 2013 | 8:41 pm
      edit
    • Oct 24 2013 | 8:43 pm
      sounds like you're looking for the object "stripnote"?
    • Oct 24 2013 | 9:13 pm
      stripnote is used in combination with velocity. It deletes every zero. My patch for many reasons works different. I don't use the velocity output (not for this part of the patch). I just need the note output of ddg.mono stop outputting values when the key is released.
      Do you think that's possible?
    • Oct 24 2013 | 9:21 pm
      Possible? That's a silly question when dealing with max ;) Everything's more or less possible.
      if the key is released then *velocity* is zero.
      Cross over the pitch and velocity lines, go into a [gate] - velocities of non-zero will open the gate, zero will close it, blocking out the pitches.
    • Oct 24 2013 | 9:32 pm
      nice :) thanks a lot!! ..wasn't too difficult in the end..