Max not recognising multiple serial ports on PC

    Jan 24 2006 | 11:52 pm
    Hey there, I've just installed a Quatech QSP-100. It is a PCMCIA card that gives four RS232 serial ports. Windows XP recognises the four new ports and has assigned them as COM4, COM5, COM6, COM7. they are all set to 9600 baud, 8 data bits, one stop bit and no parity bit, same as my on board serial port - that Max recognises. Is there anything i need to do to encourage (force) max to see and access these ports? I have programmed a basic stamp from all four new ports so they are installed properly. I'd greatly appreciate any advice, thanks