Output to Digital Performer

    May 09 2006 | 9:25 pm
    I recently started using DP, and I noticed I can assign pairs of Max/MSP outputs as stereo-bundle inputs in DP (starting with 1/2, going to 15/16). However, I tried each of the pairs and none sent a signal from MSP to DP. Do I need to set up an output object other than dac~ to route the signal into DP, or change a configuration in MSP or DP? Thanks in advance for any help.

    • May 10 2006 | 12:00 am
      Use soundflower soundflowerbed etc... to ping pong with MSP be carefull to feed back. But in fact i don't know what's about those MSP ins and outs i have in my DP to If anyone knows??? Hubert
    • May 10 2006 | 12:17 am
      These are Rewire channels. In order to make use of these, switch the MaxMSP audio driver to ad_rewire in the DSP Status window.
    • May 10 2006 | 3:40 am
      Make sure you are in rewire mode in the DSP Status. Also in DP you must be in record enable with input monitoring on. Also in DP in your hardware input monitoring pref, make sure you are at "always" play thru....