Pluggo parameters don't work with Digidesign control surfaces ?

Salvator's icon

Hi,

I found that pluggo parameters are not controlable with digidesign control suface. (tested from the encoder of the digi 002 and control 24)

Any possible fix ?

Thanks,

SAlvator

Andrew Pask's icon

Hi Salvator,

We do not have one of these to test or develop with - in the short term I would say that no fix is imminent.

Sorry about that....

-Andrew

arendownie@yahoo.com's icon

I ran into this problem before- Use flip mode on the surface and it works fine (at least with the command-8). Not sure about the others... -ARen