RNBO Move Takeover Experimental Alpha 1.4.6-alpha.0 Released

Ben Bracken's icon

We've just released the RNBO Move Takeover 1.4.6-alpha.0.

This release brings Link Audio support, expanded transport control and automatic MIDI device reconnection.

Learn more about RNBO Move Takeover features:
https://cycling74.com/products/rnbo/move

RNBO Move Takeover does not require an installation of Max or RNBO to run and edit graphs on the device, however Max 9.1.3+ and RNBO 1.4.4+ are required for development, authoring and exporting of patches. RNBO 1.4.6 is recommended.

Download the .swu and check out the change log on the release page:
https://cycling74.com/releases/rnbo-move/1.4.6-alpha.0

Changelog

Web UI: 2.5.0-beta.1

  • see 2.5.0-beta.0 release page for changelog (beta.1 was just a packaging change)

  • added support for link audio and general link configuration

Runner: 1.4.6-12~beta.0 (built against RNBO 1.4.6)

  • see release page for changelog

  • added relay for link audio configuration

  • the link audio bridge now talks to jack_transport_link over UDP/OSC instead of JACK

Jack: 1.9.22-224ca312

  • fixed several MIDI SysEx bugs in the Move driver, driven by issue #25

    • outgoing SysEx containing three zero bytes on a 3-byte boundary was truncated and the remainder of that SPI transfer dropped, so the message arrived unterminated. Roland DT1 style parameter writes hit this whenever the address and value bytes are zero. Fixed upstream in the move-spi submodule and confirmed on hardware

    • a SysEx of 64 bytes or more arriving as a single JACK event wrote past the end of a fixed size array

    • a SysEx in flight on one MIDI port could be corrupted by traffic on the other

    • SysEx delivered in chunks that are not multiples of 3 bytes had zero bytes inserted into it

Jack Transport Link: 0.0.14-beta.1

  • added link audio support and some basic link configuration

  • the time signature is now live, settable over OSC and sticky

  • OSC is now enabled by default (port 3234, searched upwards to 3249; --no-osc to disable) and carries all of link audio: clients register for a state push and send imperative commands back. osc-port is the new discovery key.

Takeover UI: 0.1.0-beta.36

  • increase transport tempo max to 999 bpm to match link

  • fixed initial graph loading on a fresh install when runner startup takes longer than the splash screen; retry the load request every 250 ms until it is sent

  • show Runner starting... above the main menu while waiting, changing to Runner still starting... after 30 seconds without stopping retries

  • explicit graph loads, clears, reloads and patcher loads cancel pending initial graph loading

Resources