Forums > MaxMSP

Can I use send and receive on the Preset object?

Jun 29 2014 | 12:31 pm

I tried to use it but it didn’t work. I’m not sure if I did something wrong. I’m strongly assuming it should work… because that would make sense.

Jul 02 2014 | 2:55 am

As far as i know it isn’t possible.
I think you just have to make your patch with preset and the pattr objects in a patch, and then send a number in to control which preset is active.

Jul 02 2014 | 10:31 pm

not even inlets and outlets will work. [preset] and [grab] always only work with the objects directly connected to them.

a solution could be to use a bunch of [f ] objects with [preset] and sync them with the real controls.

Viewing 3 posts - 1 through 3 (of 3 total)

Forums > MaxMSP