Forums > MaxMSP

iCube(X) System + Sensors (Evolver)

May 24 2006 | 6:04 am

Well, a while back I bought this guy’s whole interactive art setup. It
included the iCube System, an EZIO board, MAX/MSP, Jitter, and a big pile of
sensors and electronics.

Anyway, turns out I don’t have much use for the iCube System, so I’m
considering selling it along with a bunch of sensors.

-The current iCubeX system costs $600 and can be found here: /products_id/28
-I however own the previous version, simply "iCube". I did some research and
as far as I can tell, it is the same thing as the iCubeX system, except the
firmware is version 4.0, not 4.1. This can be updated for $50. 4.1 adds some
other functionality that may or may not be useful to you.
-You can read about it here: _id/100
-BTW, I have the manual and power supply.

-As far as sensors and electronics, there are a few sensors wired up for use
with the iCube including an LED, a potentiometer, two optical distance
sensors, and a third party FSR (force sensing resistor) (which is a small
1"x1" circle on a stalk) wired up to work with the iCube.
-Also are a bunch of wires designed to work with the iCube, however they
have no sensors attached to them. The amount to about 20 channels of data
(judging by the pins).
-Finally I have a box of miscellaneous potentiometers and sliders (some with
LEDs on them).

So that’s a slightly old iCube system + about $200-400 in sensors.
Anybody want it for $500? Is that a reasonable price?

And if anybody is willing to trade a D.S. Evolver for it, that’s what I’m
planning on buying.

Thanks, sorry if this is ot or against the rules.

Morgan Sutherland

Jun 01 2006 | 6:13 pm

Viewing 2 posts - 1 through 2 (of 2 total)

Forums > MaxMSP