Forums > MaxMSP

Route patch cords Error : Out of Ram

Nov 11 2013 | 1:48 pm


I created a big project and i wanted to route all the patch cords.

I made the mistake (i knew i should not) of selecting all elements and tried to route patch cords.

The result is that (i believe because of ram) the program crashed. Even though i had saved it just before i tried routing the patch cords i cannot open it again. So i believe that every time i try opening it max tries to route the patch cords.

So is there a place in the code that i can edit with notepad so that on next start-up max will not try to route the patch cords and the program will start?

I am not sure if i got it right,

Thanks in advance for your help.

Viewing 1 post (of 1 total)

Forums > MaxMSP