KatKaDe

I am trying to add a STOP the Sound Engine button to the existing START the Sound engine button.

The START button acts as a stop button upon clicking twice.

I've separated them, but when selecting which sounds/intervals to listen to, there is a myriad of sounds and not one distinctive. And it doesn't sound good at all.

I am trying to add a STOP the Sound Engine button to the existing START the Sound engine button.
The START button acts as a stop button upon clicking twice.
I've separated them, but when selecting which sounds/intervals to listen to, there is a myriad  of sounds and not one distinctive. And it doesn't sound good at all.
Any solution?


startstop-sound-engine

Thanks Source Audio, but the problem still exists. There are still myriad of sounds when I click on the On button.

You can't send note outs lasting 5 seconds and expect that they would

So You have to stop all sounding notes, before starting new ones.

Of course in case that they did not stop by themself before.

I would suggest sending all notes off message whenever You

Just make sure You send this to the same midi device

Now that is Your other problem.
You can't send note outs lasting 5 seconds and expect that they would
stop if You send them new start message.
So You have to stop all sounding notes, before starting new ones.
Of course in case that they did not stop by themself before.
I would suggest sending all notes off message whenever You
start or stop the Engine.
Here is patch doing so.
Just make sure You send this to the same midi device


That is controller number 120 with value 0

Any synth receiving that midi message has to stop sounding

You can send it from max with ctlout or with midiout message.

Here is example doing so with both, and sending to all 16 midi channels.

There are other solutions to turn sounding notes off,

but in Your patch there are just tooooo many noteout objects,

so it is easier to just send 1 message to the synth to stop.

Now to all notes off
That is controller number 120 with value 0
Any synth receiving that midi message has to stop sounding
You can send it from max with ctlout or with midiout message.
Here is example doing so with both, and sending to all 16 midi channels.
There are other solutions to turn sounding notes off,
but in Your patch there are just tooooo many noteout objects,
so it is easier to just send 1 message to the synth to stop.


And after having a close look in the patch, I found few things that could be

And after having a close look in the patch, I found few things that could be
improved a bit.
here are the suggestions :


Start/Stop Sound Engine