Using Set to change a length of a clip in the API


    Aug 28 2013 | 8:24 pm
    Hi - I haven't tried this before. I am not sure how to feed a value into a "set length" message. It has only one inlet to use (i tried using a pack oject to send a variable - but that didnt work)
    Any ideas gratefully acepted
    Best Regards
    Richard Soupsounds

    • Aug 28 2013 | 10:33 pm
      Perhaps I'm misremembering, but isn't the length "get only?"
      ...Oh. Right.
      If the clip is looping, you can use the loop_start and loop_end to modify stuff - that stuff is get/settable
    • Aug 29 2013 | 7:04 am
      I think your right. I thought lengh was midi-able in Ableton and therefore accessible by max.
      The same question would go for loop_end, set allows you to set a specific value, how can I input a variable value into set.
      Best regards
      Richard