okuphuzi

I'd like to be able to modify the output of a phasor~ so it ramps just like the output from curve~, based on a given curve parameter from -1 to 1. What is the best and/or most efficient way to go about doing that?

comment

message

ezdac~

curve~

live.scope~

edge~

delta~

phasor~

I'd like to be able to modify the output of a phasor~ so it ramps just like the output from curve~, based on a given curve parameter from -1 to 1.  What is the best and/or most efficient way to go about doing that?

I'd like to be able to modify the output of a phasor~ so it ramps just like the output from curve~, based on a given curve parameter from -1

how-can-i-modify-the-output-from-phasor~-so-it-ramps-like-curve~

Ah yes. I knew the answer would be obvious :-). Thanks

How did you translate from 0.7 to 3.0 for the curve parameter? I don't see an obvious way from looking at those two numbers.

Edit: the two curves do differ slightly (scale~ 3. is slightly different than curve~ 0.7). I will try to figure out how to map exponents between curve~ and scale~

Ah yes.  I knew the answer would be obvious :-).  Thanks

How did you translate from 0.7 to 3.0 for the curve parameter?  I don't see an obvious way from looking at those two numbers.

Edit:  the two curves do differ slightly (scale~ 3. is slightly different than curve~ 0.7).  I will try to figure out how to map exponents between curve~ and scale~

https://cycling74.com/forums/compare-function-in-curve-mode-to-scale-and-scale

I don´t know why the curve of each object is different and never got an answer how to match them.

I think the scale in gen~ is also diffrent. 

I don´t know why the curve of each object is different and never got an answer how to match them.
I think the scale in gen~ is also diffrent. 


How can I modify the output from phasor~ so it ramps like curve~?