encoder audio

I'm working on a project, where I'd like to implement a single dial EQ.

Basically, it is a "treble" control, just like in those old hi-fi amps. A single knob to cut or add more bass and to cut or add more highs, at the same time.

I've done something with a filtergraphs and cascades and such, but it is sooo overkill.

Is there a more simple, more elegant way to do this?

prepend

filtergraph~

scale

live.dial

message

loadbang

cascade~

spectroscope~

noise~

This is so embarrassing.
I'm working on a project, where I'd like to implement a single dial EQ.
Basically, it is a "treble" control, just like in those old hi-fi amps. A single knob to cut or add more bass and to cut or add more highs, at the same time.
I've done something with a filtergraphs  and cascades and such, but it is sooo overkill.
Is there a more simple, more elegant way to do this?

Hi Guys,
This is so embarrassing.
I'm working on a project, where I'd like to implement a single dial EQ.
Basically, it is a "treble" contro

one-knob-eq

simpler? i think it is still a lot too simple. i am sure there should be a quadratic or logarithmic distortion in the parameter mapping.

It shouldn't be accurate or ... well .. proper.

This one will sit at the end of a stompox style distortion thing, it should be a "TONE" control ...

It is, unfortunately.
It shouldn't be accurate or ... well .. proper.
This one will sit at the end of a stompox style distortion thing, it should be a "TONE" control ... 

For that purpose 6 db will be quite unefficient.

For that purpose 6 db will be quite unefficient.
You could use cross~ and mix the output
to get desired effect in a simple way.



you can get closer to those tone knobs on guitar amps if you go + or - on one single high-shelf filter(you don't need the lo-shelf in your patch), with a center freq somewhere around 2k(around 1k or even 800 if you want something more extreme). and as SourceAudio mentioned: needs to dip or raise more than 6dB.

One knob EQ