billyanok

I have a bit of a brain teaser in regard to filtering incoming OSC commands.

2 variables incoming, filter to output only when variable 2 has changed.

This is part is solved but tricky when it comes to a preset where variable 2 remains constant.

Hard to explain, I think I might be missing something simple here?

You will need the CNMAT "OSC-route" object included in the CNMAT package.

comment

message

loadbang

button

preset

slider

unpack

fromsymbol

osc-route

tosymbol

change

join

panel

I have a bit of a brain teaser in regard to filtering incoming OSC commands.
2 variables incoming, filter to output only when variable 2 has changed.
This is part is solved but tricky when it comes to a preset where variable 2 remains constant.
Hard to explain, I think I might be missing something simple here?
I've attached a small example.

Hola,
I have a bit of a brain teaser in regard to filtering incoming OSC commands.
2 variables incoming, filter to output only when variable

osc-stream-question

I don't really understand your pseudo-OSC formatting, and unless I change that, I can't get your patch to work at all.... you should have the fromsymbol before the osc-route. No need for the separator argument, either. If I just pack the osc message into the format /test 100 200, which is how you would usually use osc if the messages go to the same place, the patch works fine.

The OSC is unorthodox as I'm receiving this format '/test/$1/$2'

from another machine on an installation. This is not the correct syntax for what I need but this cannot be changed. I'm extracting the $1 and $2 values for further use in a much bigger patch.

Maybe I wasn't clear enough about my expectations in the patch?

If you move slider 1 there should be no output in the bottom "Final output" stage.

If you move slider 2, this will trigger the 'join' object to bottom "Final output" stage

Does this not work for you? I just copied from my original post and it seems to work for me?

The tricky bit is when a preset is saved with duplicate slider 2 values, no output ?

Hello Mattyo,
Thx for your reply.
The OSC is unorthodox as I'm receiving this format '/test/$1/$2'
from another machine on an installation. This  is not the correct syntax for what I need but this cannot be changed. I'm extracting the $1 and $2 values for further use in a much bigger patch.
Maybe I wasn't clear enough about my expectations in the patch?
If you move slider 1 there should be no output in the bottom "Final output" stage.
If you move slider 2, this will trigger the 'join' object to bottom "Final output" stage
Does this not work for you? I just copied from my original post and it seems to work for me?
The tricky bit is when a preset is saved with duplicate slider 2 values, no output ?
I hope I've made it bit clearer?
Thx, 
Bill

OSC stream question